You can have a sticker cut with your name on
it to go onto your bag.
The stickers are made from a sign writing vinyl ,
it will not last forever but is a cheap way of
personalising your bag.
The stickers come in either Black or White.
The following information will help you will the
sticker application
Before you start read all instructions first.
You will notice that the sticker comes in three layers.
The top which is a cream piece of application tape
The middle which is the lettering
And the bottom which is a stiff piece of paper
Do not peel any of the sticker pieces until you have read the
instructions and you have tried the
tester on the inside of your bag.
STEPS
1. Clean the surface of the bag with a little metho
2. Line the sticker up to the area of the bag that you
want to
stick it to, to make sure that it will fit.
If you plan to stick it on the side between the straps make sure
it will fit there first before you try to apply it.
3. Place the bag on a hard flat surface to apply the sticker,
if you can put a flat piece of board inside the bag it will work best.
4. Place the sticker on a flat surface and rub over with
a flat object
(egg flipper) This helps the sticker to stay onto the top layer.
5. Peel off the back paper from the sticker, you should
be able to
see and feel the sticky side of the lettering. DO NOT peel the letters
off the application tape they all go on together
The application tape will be removed after you have completed
steps 6 & 7
6. Place the sticker on the bag, try to start from one
end and work
your way along
7. Rub over the sticker with a flat object, before removing
the
masking tape top layer.
8. Peel back the masking tape. You may have to GENTLY
rub
over the letters to remove any bubbles. You care prick the bubbles
with a pin if they are to large. Most bubbles will disappear in time.
Good Luck
